Lincoln Corsair: Wipers and Washers / Removal and Installation - Rain Sensor
Materials
Name |
Specification |
Motorcraft® Ultra-Clear Spray Glass Cleaner ZC-23 |
ESR-M14P5-A
|
Removal
-
Remove the interior rear view mirror.
Refer to: Interior Rear View Mirror (501-09)
.
-
Remove the rain sensor.
-
Disconnect the electrical connector and position aside
-
On both sides.
Release the retainers.
-
Remove the rain sensor.
Installation
-
Clean the windshield glass area of foreign materials.
Material: Motorcraft® Ultra-Clear Spray Glass Cleaner
/ ZC-23
(ESR-M14P5-A)
-
NOTE:
If the rain sensor gel pack is damaged, install a new rain sensor.
Inspect the rain sensor gel pack for damage.
-
Install the rain sensor and connect the electrical connector.
-
Install the interior rear view mirror.
Refer to: Interior Rear View Mirror (501-09)
.
Repair
NOTE:
This procedure may be carried out on rubber hoses only. If a
plastic washer hose is damaged, a new washer hose must be installed.
Locate and verify the damaged washer hose...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear window wiper pivot arm.
Refer to: Rear Window Wiper Pivot Arm (501-16)
...
Other information:
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
Removal
NOTICE:
Failure to match the replacement solenoid service band to
the original solenoid can cause damage to the transmission or erratic
engagements and shifts...
Special Tool(s) /
General Equipment
Boot Clamp Pliers
Materials
Name
Specification
Motorcraft® Premium Long-Life GreaseXG-1-E1
ESA-M1C75-B
Removal
NOTE:
Left hand (LH) side shown, right (RH hand side ) similar.
Remove the tie rod end...