Lincoln Corsair Manuals

Lincoln Corsair: Transmission Cooling - Automatic Transmission – HF45 / Removal and Installation - Transmission Fluid Cooler

Removal

  1. Remove the A/C condenser.
    Refer to: Transmission Fluid Cooler Tubes (307-02A Transmission Cooling - 8-Speed Automatic Transmission – 8F35/8F40, Removal and Installation).
  1. Release the clips and remove the transmission fluid cooler from the radiator.

Installation

  1. Install the transmission fluid cooler to the radiator and engage the clips.
  1. Install the A/C condenser.
    Refer to: Transmission Fluid Cooler Tubes (307-02A Transmission Cooling - 8-Speed Automatic Transmission – 8F35/8F40, Removal and Installation).

    General Procedures - Transmission Fluid Cooler - Backflushing and Cleaning - Plug-In Hybrid Electric Vehicle (PHEV)

    Special Tool(s) / General Equipment Transmission Cooling System Heated Flusher Materials Name Specification Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV WSS-M2C949-A, MERCON® ULV  Activation NOTE: Use transmission fluid specified for this transmission...

    Removal and Installation - Transmission Fluid Cooler Tubes - Plug-In Hybrid Electric Vehicle (PHEV)

    Materials Name Specification Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV WSS-M2C949-A, MERCON® ULV  Removal With the vehicle in NEUTRAL, position it on a hoist...

    Other information:

    Lincoln Corsair 2020-2024 Service Manual: Diagnosis and Testing - Electric Powertrain Control


    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. SGM REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action APIM U0293:00 Lost Communication With Hybrid/EV Powertrain Control Module 'A': No Sub Type Information GO to Pinpo..

    Lincoln Corsair 2020-2024 Service Manual: Removal and Installation - Heated Rear Seat Module


    Removal NOTE: The heated rear seat module is located under the LH (left hand) rear seat cushion substrate. Remove the heated rear seat module. Remove the pin-type retainer. Remove the heated rear seat module from the rear seat cushion substrate. Disconnect the electrical connectors. Installation To install, reverse the..

    Categories

    Second Stage: Checking Tire Pressure

    WARNING: If the tire does not inflate to the recommended tire pressure within 15 minutes, stop and call roadside assistance.

    WARNING: The power plug may get hot after use and should be handled carefully when unplugging.

    Check the air pressure of your tires as follows:

    Lincoln Corsair. Second Stage: Checking Tire Pressure

    read more

    Copyright © 2024 www.licorsair.com